A lightning strike begins with a simple question from the insurer or assessor: what happened, when, and what was damaged? Whether it's a telecom tower in India, a solar power plant in Vietnam, or a warehouse in Malaysia, the answer is rarely obvious. Often, no one saw the strike, and the damage only becomes apparent later, when equipment malfunctions.
This guide is intended for site managers, installers, and distributors. It explains which documents to gather, how lightning location data can supplement the claim, and which field checks to document. However, the final decision regarding a claim always rests with the insurer, according to the terms of each policy.
What documents does the insurer expect after a lightning strike?
An insurer typically expects a prompt claim, a clear description of the incident including the date and time, photos or videos of the damage, a list of damaged property, and invoices for emergency repairs. These recommendations are outlined in the National Association of Insurance Regulators' (NAIC) claims reporting guide.
The basics of any insurance claim
The NAIC Post-Disaster Claims Guide recommends notifying your insurer as soon as possible and photographing or filming the damaged areas and property. It also advises keeping all documentation of emergency repairs carried out to prevent further damage.
- Date, time period and location of the storm.
- Photos and videos taken before any repairs.
- List of damaged equipment, with references and, if possible, proof of purchase.
- Estimates and invoices for emergency and permanent repairs.
Furthermore, the expert may visit the site. Therefore, the damaged parts must be kept until the insurer gives their approval.
How do you document an impact that no one has seen?
An impact can be documented using lightning location data: dated and geolocated recordings of cloud-to-ground lightning strikes detected by a location network. This data indicates whether thunderstorm activity was observed near the site at the time of the storm. It supplements the evidence but does not, on its own, establish the extent of the damage.
Damage does not require a direct impact
IEC 62305-1 (2024 edition) distinguishes four sources of damage (S1 to S4): an impact on the structure, an impact near the structure, an impact on a connected service, and an impact near a connected service. Therefore, electronic equipment can be damaged by an impact located at a certain distance, via power or telecommunications lines, without leaving any visible trace on the building.
What LPS Strike Radar offers
LPS Strike Radar uses data from a global lightning location network. Its certificates are based on recorded cloud-to-ground strikes. Two of its documents are useful for a claims file:
- Lightning strike certificate : an assessment, in percentage, of the probability that an impact hit a specific site on a given date, based on GPS coordinates, intensity (kA) and polarity of recorded strikes.
- The keraunic report : lightning activity in an area over a period of time, with mapping of impacts and intensity statistics.
However, both of these documents require that the site has been covered by an LPS Strike Radar during the period under consideration. First, it is necessary to verify if an existing probe already covers the site and how long it has been archiving events: these deliverables do not provide access to events prior to this archiving. For a complete overview of these deliverables and site monitoring, see our article Strike Radar: Documenting Lightning Activity at a Site.
What field evidence complements the lightning data?
Field evidence shows what actually happened to the installation and equipment. This includes the lightning protection system inspection report, the condition of the surge arresters, the lightning strike counter reading, and the equipment event logs. Combined with the lightning data, this provides the expert with a coherent picture.
Lightning protection system
A lightning protection system is the set of interceptors, down conductors, and grounding connections that intercept a lightning strike and dissipate it to earth. After a storm, an inspection by a qualified professional can identify any damage: signs of melting, loose fixings, damaged conductors, or damaged connections. IEC62305-3:2024 governs the inspection and maintenance of these systems; for early streamer emission (ESE) lightning rods, NF C 17-102:2011 (§8) further requires inspection after every known lightning strike.
In addition, a lightning strike counter Compt@ir installed on a down conductor records the lightning currents detected on that conductor. Photos of its display before and after the storm can supplement the report. An unchanged reading does not rule out a lightning-related event or damage transmitted through incoming lines.
Electrical and electronic equipment
- Surge protectors: status indicators, disconnections, cartridges replaced.
- Event logs: inverter alarms on solar power plants, telecom alarms, supervision history (SCADA).
- Reports from the electrician or maintenance technician, with a list of defective cards.
How to compile a lightning claim file step by step?
A lightning claim file is compiled in a specific order: secure the site, notify the insurer, assess the damage before repairs, gather technical evidence, and then add the lightning data for the date and location. Each step must be dated and kept in the same file so that the expert can follow the chronology.
- Secure the site and isolate damaged equipment if necessary.
- Report the claim to the insurer promptly, within the time limits stipulated in the contract.
- Photograph and film before any repairs; keep the damaged parts.
- Have the lightning protection system and electrical installation checked by a qualified professional.
- Check the status of the surge protectors, the lightning strike counter and the event logs.
- Request the lightning strike certificate or keraunic report for the site, date and time range.
- Keep all quotes, invoices and correspondence with the insurer.
Record the verification results, photos, and follow-up actions for each site. The LPS Strike Radar documents then complete the installation's file.
What can't lightning data prove?
Lightning data cannot prove the damage itself, its cost, or the acceptance of a claim. A lightning strike certificate assesses a probability; it does not record the condition of the equipment. Only an on-site assessment can determine the damage, and the insurer makes the final decision according to the policy.
- The certificate gives a probability, not a certainty.
- Damage via incoming lines can originate from a more distant impact.
- If no LPS Strike Radar probe was covering the site during the event, these event deliverables are not available for that date. The Nsg certificate remains available worldwide, but describes a ten-year average lightning density, not a specific storm.
That is why it is preferable to install a probe as soon as a site is put into service, rather than after a disaster.
Conclusion
A lightning claim relies on a comprehensive file: prompt reporting, photos taken before repairs, damaged parts preserved, installation verification, and equipment logs. Lightning location data, such as the lightning strike certificate or the LPS Strike Radarkeraunic report, supplements this file with dated and geolocated information. However, these data do not replace an on-site assessment, and the final decision rests with the insurer. Finally, check if an LPS Strike Radar probe already covers the site and for how long; if not, activate one before the storm season to begin building this local history.
Frequently Asked Questions about Lightning Strike
Does a lightning strike certificate guarantee that my claim will be accepted?
No. The certificate completes the claim file with dated and geolocated lightning data. The insurer processes the claim according to the contract and the findings made on site.
Is it possible to obtain data for a storm that predates the creation of my own probe?
First, check if an existing LPS Strike Radar probe already covered the site on that date. The lightning certificate and keraunic report are only available for the archived coverage period. The Nsg certificate remains available worldwide, but its ten-year average does not document a specific storm.
Can lightning damage equipment without any visible impact on the building?
Yes. IEC 62305-1 includes among the sources of damage impacts near the structure and impacts on or near connected services, which can reach electronic equipment via power or telecommunications lines.
Sources
- NAIC, Post-Disaster Claims Guide (link in text).
- LPS Strike Radar, presentation of the service and deliverables (link in the text).
- IEC 62305-1:2024, Protection against lightning, part 1: general principles (general reference).
- IEC 62305-3:2024, Protection against lightning, part 3: physical damage to structures and human risks (link in text).
- IEC 62858, Lightning strike density based on lightning location systems, general principles (general reference).